Preparing Wing Tips

1.                   Cut out wing tip parts using templates. Make 4 pieces. (Remember shiny/dull surfaces) Make 2 shiny up and 2 shiny down.

2.                

Hint:  Apply insignia material to 1st side –           trim to wing shape. Apply 2nd insignia material to other           side, trim again.

Put insignia cloth re-enforcements on wing tip points (On both surfaces, back to back).

3.       Apply edging material (black 1.5 oz.) to all edges. Edging will go over insignia cloth.

NOTE: Edging strips have color marking (ID) on one end.

                   RED color strip is for inside edge – 27”.

                   BLUE color strip is for both remaining edges – 32”.

          Kit contains required amount.

                   NOTE:  Do not use wrong colors.

4.      Aluminum eyelet to be inserted in each tip. The exact location is

         determined by edging and insignia re-enforcement position. Install

         eyelets on each corner. (Gauge by eye is fine – not a critical step).

HINT: Burn/melt a snug hole for your eyelet.

          ¼“ eyelet is preferred.